Origami-Instructions.com

The Swallow Paper Airplane

The Swallow is a classic paper airplane design that flies really well. It has been called the World's Best Paper Airplane.

Made this origami? Comment and Submit your photo using the comment box at the end of this page!

You can view our video below and / or follow our photo instructions below that:

Start with a piece of printer paper. This can be either 8.5 by 11 inches, or A4 size. It must be rectangular, not square. Origami paper will not work for this. It's too light and small. Larger paper airplanes generally fly better.

Valley fold the top left corner over to the right as shown. Crease well.

01-swallow-paper-airplane

02-swallow-paper-airplane

Unfold the paper, then repeat the last fold on the other side of the paper.

03-swallow-paper-airplane

04-swallow-paper-airplane

Do a mountain fold horizontally through the intersection of the crease marks.

05-swallow-paper-airplane

06-swallow-paper-airplane

Unfold the last fold, then begin to collapse the paper as shown in the next five (5) photos. This is somewhat similar to a water balloon base , with some extra paper at the bottom (since we started with a rectangle not a square).

07-swallow-paper-airplane

08-swallow-paper-airplane

09-swallow-paper-airplane

10-swallow-paper-airplane

11-swallow-paper-airplane

12-swallow-paper-airplane

Fold corner A upwards as shown. Repeat for corner B.

13-swallow-paper-airplane

14-swallow-paper-airplane

Now fold both A and B downwards. Next, fold C and D to the centerline, then unfold.

15-swallow-paper-airplane

16-swallow-paper-airplane

17-swallow-paper-airplane

18-swallow-paper-airplane

Make a squash fold as shown to bring C to the centerline. This is similar to making a fin in the fishbase . Repeat on the right side.

19-swallow-paper-airplane

20-swallow-paper-airplane

21-swallow-paper-airplane

22-swallow-paper-airplane

23-swallow-paper-airplane


Fold the bottom edge of the piece up, then unfold. Cut or tear along the creaseline, and save the extra piece for later.

24-swallow-paper-airplane

25-swallow-paper-airplane

26-swallow-paper-airplane

Put the cut piece aside. Mountain fold the top point of this piece (the wings) to the back as shown.

27-swallow-paper-airplane

28-swallow-paper-airplane

Mountain fold the wing section in half as shown. Now fold the wings down as shown in the next five (5) photos. The front of the wing base should be slightly higher than the back, by about 2-3mm. When viewed from the front or back, both wings should be at the same angle, angled upwards towards the tips.

29-swallow-paper-airplane

30-swallow-paper-airplane

31-swallow-paper-airplane

32-swallow-paper-airplane

33-swallow-paper-airplane

Now fold the tips of each wing upwards as shown. Each tip should be at the same angle to its wing.

34-swallow-paper-airplane

35-swallow-paper-airplane

Go back to the strip of paper you cut or tore earlier. We'll use this for the fuselage (body) of the Swallow. Fold it in half lengthwise.

36-swallow-paper-airplane

37-swallow-paper-airplane

About 1 inch from the end of the fuselage, cut or tear halfway across. Then fold down each half as shown to form the horizontal stabillizer (tail). Each half should be at about 90 degrees to the fuselage.

38-swallow-paper-airplane

39-swallow-paper-airplane

40-swallow-paper-airplane

41-swallow-paper-airplane

Insert the other end of the fuselage into the wing section. Slide it all the way forward.

42-swallow-paper-airplane

43-swallow-paper-airplane

Turn over your completed Swallow Paper Airplane!

44-swallow-paper-airplane
Did you make this origami? If so, upload your photo (2MB limit)via the comment box below. You can login with your Facebook, Twitter, Google or Yahoo accounts.
View Site in Mobile | Classic
Share by: